NEWSLETTER

SPEC High Temp

Mastic polyester à résistance accrue aux hautes températures

Variantes

contenancenuméro d'article poids quantité par carton
gris 6885 0,5 kg18
gris68904,5 kg1

Degré de brillance

mat
SPEC High Temp

    Description

    Mastic polyester de haute qualité avec une résistance accrue aux hautes températures, même 200oC, partiellement conducteur électrique, principalement destiné au traitement de surface en préparation d’un revêtement en poudre. Le produit a une flexibilité adéquate et une très bonne adhérence sur divers substrats après la préparation recommandée.

    Avantages

    • Très bonne adhésion aux métaux.
    • Bonne qualité de ponçage.
    • Surface parfaitement lisse après le meulage.
    • Résistance aux hautes températures, jusqu’à 200°C.
    • Conducteur d’électricité.

    Informations importantes concernant l'utilisation du produit

    • Przetrzeć odtłuścić

      dégraisser

    • Mieszanie wg wagi

      mélange selon le poids
      100:2

    • Czas życia

      durée de vie en pot
      6 ÷ 8 min / 20°C

    • Czas utwardzania

      temps de durcissement
      3 ÷ 4 h / 20°C

    • Szlifowanie

      P80÷P120.
      P120÷P320.

    Processus d'appliquation

    • Zastosowanie
    • Use

      High-temperature body fillers intended for filling surfaces that will painted and hardened at temperatures up to 200°C.

    • Mieszanie wg wagi
    • Mixing ratio by weight

      Body filler : 100
      Hardener : 2

      Stir thoroughly until achieving an uniform mixture. Stir carefully so as not to air the body filler.

    • Czas życia
    • Layer thickness

      Body filler should be applied in several thin layers. Before the application of each additional layer the filler should be cured. Do not exceed total thickness of 5 mm.
      Pot life: approx. 6÷8 minutes at 20°C.

    • Czas utwardzania
    • Hardening time

      Approx. 3-4h at 20°C.
      Approx. 2h at 60°C.
      Body filler top layer tends to stick to the sandpaper. After the initial sanding of the top layer, the clogging wears off.
      Temperatures below 20°C increases significantly the hardening time.

    • Szlifowanie
    • Sanding

      Course sanding (dry): P80÷P120.
      Finishing sanding (dry): P120÷P320.

    • Informacja
    • Further works

      After hardening, the product should be sanded according to the manufacturer’s instructions until a perfectly smooth surface is obtained. It is recommended to wait 12 hours before powder coating. The surface should be cleaned, degreased and primed and then covered with paint.

    • Informacja
    • General notes

      -Excessive amounts of hardener will cause problems with bleaching of the topcoat!
      -The rooms should be well ventilated.
      -Tools should be washed directly after application.
      -Use the efficient personal protection equipment during the 2K products application. Protect the eyes and air passages.

      Caution: To maintain safety, always follow the instructions given in the MSDS for the products.

    Formulaire de renseignements

    

         
      Voir aussi d'autres produits
      Wyjście 
      Go to top