Glass Fibre

Glass fibre reinforced polyester putty with reduced styrene content

Variants

Art.No.ColourCapacityQuantity per carton
18125grey1 l6

Gloss grade

matt
Glass Fibre
New

Technical documentation

Description

Structural polyester putty reinforced with glass fibre, recommended for repairing large dents and holes in vehicle bodywork. Particularly suitable for repairing areas affected by corrosion and for reinforcing weakened surfaces.

Advantages

  • Contains <10% styrene.
  • Very good adhesion to metal.
  • Excellent mechanical strength combined with good flexibility.
  • Short hardening time.
  • Good sanding properties.

Substrates

The product has very good adhesion to various substrates. It can be applied over:

  • Bare steel and aluminum after flatting and degreasing.
  • Zinc coated steel after flatting and degreasing.
  • Sanded glass fibre (GFK/GRP), polyester putties, acrylic and epoxy primers and existing coatings in good condition.

Caution: Do not apply the putty directly on the reactive primers, 1K acrylic and nitrocellulose products.

Important informations

  • Przetrzeć odtłuścić

    degrease

  • Mieszanie wg wagi

    Mixing ratio by weight
    100 : 2

  • Czas życia

    Pot life
    4 ÷ 7 min / 20°C

  • Czas utwardzania

    Hardening time
    20 ÷ 25 min / 20°C

  • Szlifowanie

    P80 ÷ P120
    P120 ÷ P240

Application process

  • Zastosowanie
  • Use

    Glass fibre reinforced polyester putty for car repairs.

  • Mieszanie wg wagi
  • Mixing ratio by weight

    Putty : 100
    Hardener: 2

    Stir thoroughly until achieving homogenous paste. Be careful not to create air inclusions.

  • Czas życia
  • Layer thickness

    Putty can be applied in several thin coats. After each of them the product should cure. Do not exceed the thickness of 5 mm.

    Pot life is 4 ÷ 7 minutes at 20°C.

  • Czas utwardzania
  • Hardening time

    20 ÷ 25 min at 20°C.

    Temperatures below 20°C significantly increase the drying time.

  • Szlifowanie
  • Sanding

    Coarse sanding (dry): P80 ÷ P120
    Finishing sanding (dry): P120 ÷ P240

  • Informacja
  • Further work

    Polyester putties can be over coated with:

    • 2K polyester putties.
    • 2K polyester spray fillers.
  • Informacja
  • General notes
    • Excessive amount of hardener will cause problems with bleaching of the topcoat!
    • When working with 2K products, it is recommended to use personal protection equipment. Protect the eyes and air ways.
    • Clean the guns and equipment immediately after use.
    • The rooms should be well ventilated.Caution: To maintain safety, always follow the instructions given in the MSDS for the products.

Ask about this product



       
    See also other products
    Wyjście 
    Go to top