Light

Light filling polyester putty

Variants

ColourArt. No. Capacity Quantity per carton
creamy 1257 1 l6
creamy12372,5 l4

Gloss grade

matt
Light

Video

Description

Bicomponent light filling polyester putty for car body repairs. Lower specific weight makes it not overburdening the surface as other putties.

Advantages

  • Low density.
  • Easy mixing and application process.
  • Very good sanding quality.

Substrates

The product has very good adhesion to various substrates. It can be applied over:

  • Bare steel and aluminum after flatting and degreasing.
  • Zinc coated steel after flatting and degreasing
  • Sanded glass fibre (GFK/GRP), polyester putties, acrylic and epoxy primers, existing coatings in good condition.

Caution: Do not apply the putty directly on the reactive primers, 1K acrylic and nitrocellulose products.

Important informations

  • Przetrzeć odtłuścić

    degrease

  • Mieszanie wg wagi

    Mixing ratio by weight
    100 : 2

  • Czas życia

    Pot life
    4 ÷ 7 min / 20°C

  • Czas utwardzania

    Hardening time
    20 ÷ 30 min / 20°C

  • Szlifowanie

    P80 ÷ P120
    P120 ÷ P320

Application process

  • Zastosowanie
  • Use

    Soft in working process polyester putty dedicated to car body repair.

  • Mieszanie wg wagi
  • Mixing ratio by weight

    Putty: 100
    Hardener: 2

    Stir thoroughly until achieving homogenous paste. Be careful not to create air inclusions.

  • Czas życia
  • Layer thickness

    Putty can be applied in several thin coats. After each of them the product should dry through. Do not exceed the thickness 5 mm.

    Pot life: 4÷7 min. at 20°C.

  • Czas utwardzania
  • Hardening time

    20÷30 min. at 20°C.

    Temperature below 20°C significantly increases the hardening time.

  • Szlifowanie
  • Sanding

    Coarse sanding (dry): P80÷P120,
    Finishing sanding (dry): P120÷P320

  • Suszenie promieniem IR
  • IR Drying

    5÷7 minutes of short waves, depending on the layer thickness and the type of radiator. Do not exceed the temperature of 60°C. Use as recommended by the equipment manufacturer. Caution: Wait about 5 minutes before the IR drying process

  • Informacja
  • Further work

    Polyester putties can be over coated with:

    • 2K polyester putties.
    • 2K polyester spray fillers.
    • 2K acrylic fillers.
    • 2K epoxy fillers.
  • Informacja
  • General notes
    • Excessive amounts of hardener will cause problems with bleaching of the top coat!
    • The rooms should be well ventilated.
    • Tools should be washed directly after application.
    • Use personal protection equipment during the 2K products application. Protect eyes and respiratory system.

    Caution: To maintain safety, always follow the instructions given in the MSDS for
    the products.

Ask about this product



    

    Related products

      
    See also other products
    Wyjście 
    Go to top