Aluminium

Use

Filling polyester putty especially dedicated to repair car panels exposed on temperature changes.

Mixing ratio by weight

Putty: 100
Hardener:2

Stir thoroughly until achieving homogenous paste. Be careful not to create air inclusions.

Layer thickness

Putty can be applied in several thin coats. After each of them the product should dry through. Sand before applying next layer.

Pot life 4÷7 min. in 20°C.

Hardening time

20÷30 min. in 20°C.

Temperature below 20°C significantly increases the hardening time.

Sanding

Coarse sanding (dry): P80÷P120,
Finishing sanding (dry): P120÷P320.

IR Drying

5÷7 minutes of short waves, depending on the layer thickness and the type of radiator.
Do not exceed the temperature of 60°C.
Use as recommended by the equipment manufacturer.

Caution: Wait about 5 minutes before the IR drying process

Further work

Polyester putties can be over coated with:

• 2K polyester putties.
• 2K polyester spray fillers.
• 2K acrylic fillers.
• 2K epoxy fillers.

General notes

• Excessive amounts of hardener will cause problems with bleaching of the base/top coat!
• The rooms should be well ventilated.
• Tools should be washed directly after application.
• Use personal protection equipment during the 2K products application. Protect eyes and respiratory system.

Caution: To maintain safety, always follow the instructions given in the MSDS for
the products.